However, using an Allen-Bradley motor with your drive removes the . Н Installation guidelines called out in Appendix D of the User’s Manual. Installation Instructions IN. May, Allen-Bradley. Dynamic Brake. Cat. No. KAA KBA03, KBA06, KBA Table of Contents. Find great deals for Allen Bradley Adjustable Frequency AC Drive User Manual. Shop with confidence on eBay!.
|Published (Last):||1 January 2017|
|PDF File Size:||14.40 Mb|
|ePub File Size:||9.62 Mb|
|Price:||Free* [*Free Regsitration Required]|
Check the motor and external wiring to the drive output terminals for a shorted condition. If not, manually program any remaining parameters. Correct the cause of the fault and manually clear by cycling the stop command or cycling power.
Allen Bradley Adjustable Frequency AC Drive User Manual | eBay
Check for broken wires, loose connections, or transducer loss at mA input, TB2. Hz Err Fault – F29 No valid operating frequency. Stop drive, then re-run download. Check for excess load, improper DC boost setting, DC brake volts set too high or other causes of excess current.
Save a new profile. Please select the Repairs tab for more information or to request a quote. Reset to Default Parameters and Cycle mnaual. The Adjustable Frequency AC drive is available with ratings 0.
1305 AC Drives
Check the AC line for high line voltage or transient conditions. Inspect the motor and external wiring to the drive output terminals for a shorted condition. If the motor is drawing excessive current, the motor load is manuak and will not allow the drive to accelerate to set speed.
Inspect to ensure that the ambient temperature limit has not been exceeded. Check [Minimum Freq] and [Maximum Freq] parameters. Check the external potentiometer circuit at TB2, terminals 1, 2, and 3 for a disconnected current. Reduce [Start Boost] if applicable.
Unplug the HIM from the cable or drive, then reconnect it. An attempt has been made to set the [Run Boost] parameter to vgd value greater than the [Start Boost] parameter.
Extend the deceleration time or instal dynamic brake option. Open Pot Fault – F9 An external pot is connected and the ground lead of the pot is disconnected, creating a potential drive overspeed hazard. Hz Sel Fault – F30 An unconnected adapter has been selected as the active vfdd source. Skip frequencies and skip bandwith eliminate all operating frequencies.
Overcurrent Fault – F12 Overcurrent is detected in overcurrent hardware trip circuit.
Press Enter to continue download. Replace the Communication cable. Error 2 – The number of parameters in saved profile does not equal master number. Check for external noise sources.
Allen Bradley 1305 Adjustable Frequency AC Drive User Manual
Phase U Fault – F38 A phase to ground default has been detected between the drive and motor in this phase. Overload Fault – F7 Internal electronic overload trip. Check the motor for grounded phase.
Motor Stall Fault – F6 The motor has stalled If the motor is drawing excessive current, the motor load is excessive and will not 105 the drive to accelerate to set speed.
Connect proper adapter or change active frequency source. Inspect fault buffer for fault code requiring reset.