20A UM001 EN P PDF

Rockwell Automation Publication 20A-TDJ-EN-P – July PowerFlex 70 Adjustable Frequency AC Drive User Manual, publication 20A-UM Publication 20A-INB-EN-P. The PowerFlex 70 drive contains protective MOVs and Common Mode. Capacitors referenced to ground (see below). To guard. posts; United States. Posted 1 Jun ยท llautomation. com/idc/groups/literature/documents/um/

Author: Mizilkree Zulubei
Country: Mauritania
Language: English (Spanish)
Genre: Business
Published (Last): 15 December 2011
Pages: 130
PDF File Size: 17.76 Mb
ePub File Size: 6.42 Mb
ISBN: 777-7-75139-816-3
Downloads: 99015
Price: Free* [*Free Regsitration Required]
Uploader: Tujin

When prompted, select a display language.

Factory default setting is 12 volts. Do not reduce wire gauge when using higher temperature wire. Don’t show me this message again. If the application requires the drive to be disabled without software interpretation, a hardware enable configuration can be utilized. Address the condition that caused the fault.

For detailed PowerFlex 70 information including advanced start-up. Sign in Already have an account? Good luck and be careful.

Allen-Bradley PowerFlex 70 Installation Manual

Extra jumpers or jumpers that um0011 been removed should be stored in this location for use at a later time. Install original HMI on the new drive? Enhanced and ethernet plc-5 programmable controllers pages. The information provided Does Not replace the User Manual and is intended for qualified drive service personnel only.

  DIFERANSIYEL GEOMETRI PDF

Go through the existing drive and make note of the value of every u0m01. Yellow Flashing, An inhibit condition exists, the drive cannot be started. If the Safe-Off board is removed from the drive, pins 3 and 4 of the Safe-Off Connector must be jumpered for the drive to run.

Rockwell Automation 20A PowerFlex 70 Power Jumpers User Manual | 6 pages

Posted 1 Jun Refer to user manual Posted 4 Jun Enter 2a from picture: Start-Up of the PowerFlex Table of Contents Add to my manuals Add. Started by wendaiyu31 May If you have an LCD HIM, two methods are provided, allowing the user to select the desired level needed for the application. Page 40 Running S. I suspect when you say “how to put original parameters to the new one”, you want to program a new drive with the same parameters as an existing drive.

Deutsch Dieses Instruktionsblatt kann in mehreren Sprachen unter http: Posted 31 May Then put that HMI into the new drive um00 Download the parameters into the new drive.

Start During a Start Up, the majority of applications require changes to only a few parameters. Most drives will have a jumper storage area inside the front cover.

  74LS125A DATASHEET PDF

With these parameters, you can set the following functions Other objects can occupy this space; however, airflow must not be reduced and inlet air temperature must not Press Esc to acknowledge the fault. Also See for PowerFlex 70 Reference manual – pages User manual – pages Installation instructions manual – 56 pages.

I have some questions about replacing PowerFlex Refer to the Quick Start Guide. When reading this document, look for this symbol “. To print the manual completely, please, download it. You need to be a member in order to leave a comment. Press the Enter key to display the Start-Up Menu. The information provided Does Not replace the User Manual uum001 is.

Rockwell Automation

Don’t have an account? The drive has been listed by U. See page 39 for information on other start-up routines. Step 1 Read the General Precautions Powerflex series medium voltage ac drives pages.

Not Selected Main Menu: It is very easy to do. Sign In Sign Up.